[Bioclusters] no load distrib when running IPRscan on MOSIX

[Philip MacMenamin]

Hi, 
I am trying to install interpro on a MOSIX cluster.

On the UNIX QUEUING question on the CONFIG.pl script I am not sure what to 
put. If I were running a process on the machine I would normally enter:

nice -5 mosrun -l my_job, or somthing similar.

So I have entered "mosrun queue_name mosrun -l command_line". However, it 
later asks me the queue name for the various scans, and I do not know what 
queue name to give them. I have tried things like '5', but this does not work.

When I run the scan the std.err file gives the following message:

exec: No such file or directory
exec: No such file or directory
gmake[1]: *** [blprodom.out] Error 1
gmake[1]: *** [coil.out] Error 1
exec: No such file or directory
exec: No such file or directory
gmake[1]: *** [hmmpfam.out] Error 1
gmake[1]: *** [fps.out] Error 1
exec: No such file or directory
exec: No such file or directory
gmake[1]: *** [hmmsmart.out] Error 1
gmake[1]: *** [hmmpir.out] Error 1
exec: No such file or directory
exec: No such file or directory
gmake[1]: *** [scpr.out] Error 1
gmake[1]: *** [prfs.out] Error 1
exec: No such file or directory
exec: No such file or directory
gmake[1]: *** [seg.out] Error 1
gmake[1]: *** [signalp.out] Error 1
exec: No such file or directory
exec: No such file or directory
gmake[1]: *** [tigrfam.out] Error 1
gmake[1]: *** [tmhmm.out] Error 1
gmake[1]: Target `raw' not remade because of errors.
gmake: *** [cnk_1/merged.raw] Error 2no load distrib when running IPRscan on 
MOSIX
gmake: Target `raw' not remade because of errors.

However, if I choose no to use the UNIX QUEUING system question, and enter
the same answers to all other questions it will run interpro fine. The
problem is it runs it all on the one node. (Obviously). If I enter:

mosrun gmake raw -j1 -k 2> ERROR 1> OUT or
mosrun gmake raw -k 2> ERROR 1> OUT

Leaving mosix to do the load distrib, it does not distribute the load as it 
should, instead it leaves it all on one node.

Any ideas about what I am doing incorrectly?

For instance, I don't have to install interproscan on all nodes?
 
Philip.